Avaya Configuring BayStack Remote Access Instrukcja Użytkownika Pobierz pdf (Strona 114)

Configuring BayStack Remote Access

B-20

117341-B Rev. 00

Implementation Notes

This section contains notes for operating a BayStack router at a remote site.

• If you use TFTP to upgrade or restore the router’s file system, be sure to

specify the software image file (an.exe for the AN/ANH or arn.exe for the

ARN).

• Bay Networks supports BootP service on UNIX workstations, but not PCs. If

you want to netboot and you are using a PC as your Site Manager workstation,

transfer the files you want to netboot from the PC to a UNIX workstation and

configure the workstation as a BootP server.

• On a BayStack router, you cannot use EZ-Install or Netboot directly from a

FDDI interface. On an AN/ANH router, you cannot use EZ-Install or Netboot

directly from a token ring interface.

• You need BayRS Version 8.10 or later to use Directed Netboot.

• If you have a LAN protocol analyzer available, you may want to use it to

troubleshoot BootP server communication errors. (For information about

using the Packet Capture utility or an analyzer to isolate these errors, see

“Guidelines for Using Packet Capture” and “Guidelines for Using a LAN

Protocol Analyzer” on page B-9

• BayRS Versions earlier than 7.80 do not include the Packet Capture utility.

• The 12-port ANH polls the internal repeater module for operational status; it

does not poll individual Ethernet repeater ports for connection (link) status.

Therefore, the 12-port ANH is aware of the connection between the baseboard

and repeater module, but is not aware of any connection between the repeater

module and the Ethernet network. If the repeater module interface state

reports an operational status, the 12-port ANH may continue to transmit

information through the repeater module even though a physical Ethernet

connection does not exist.

• At the AN Monitor prompt, you cannot view the contents of the local file

system on the flash memory card. Be sure to remember the name of the

configuration file when performing a Directed Netboot from the AN Monitor

prompt.

• You can issue a

boot

command from the AN Monitor prompt. Specify a local

boot by entering

for the volume name.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 137 138

Brak uwag

Avaya Configuring BayStack Remote Access Instrukcja Użytkownika Strona 114