Avaya Configuring BayStack Remote Access Instrukcja Użytkownika Pobierz pdf (Strona 67)

Configuring Netboot Services with Site Manager

308614-14.00 Rev 00

3-13

Creating the BootP Client Interface Table

The upstream router is the booting router’s next-hop router. By default, the

booting router’s synchronous interfaces automatically try to obtain IP addresses

from the upstream router. This is the EZ-Install process.

If the BayStack router using EZ-Install obtains its address from the upstream

router, and the upstream router’s interface to the BayStack router is a Frame Relay

PVC in group access mode, you must use Site Manager to connect to the upstream

router and create a BootP client interface table (in addition to a BootP relay agent

forwarding table).

The BootP client interface table allows you to specify and pair the IP address of

the BayStack router with the DLCI of the Frame Relay group access PVC.

For more information about the DLCI and Frame Relay, see Configuring Frame

Relay Services.

Note:

You do not need to create a BootP client interface table if the Frame

Relay PVC is configured to operate in direct access mode, or if the circuit is

configured to operate with Nortel Networks Standard PPP (HDLC

encapsulation).

Note:

If you are using EZ-Install over Frame Relay, you can have up to 20

PVCs for a single Frame Relay interface on the upstream router. If you have

more than 20 PVCs on the Frame Relay interface, the EZ-Install process may

fail. To ensure that the process does not fail, configure a maximum of 20 PVCs

for a Frame Relay interface.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 139 140

Brak uwag

Avaya Configuring BayStack Remote Access Instrukcja Użytkownika Strona 67