Avaya Configuring BayStack Remote Access Instrukcja Użytkownika Strona 144

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 168
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 143
Configuring BayStack Remote Access
B-20 117341-A Rev. A
Implementation Notes
This section contains notes for operating a BayStack router at a remote site.
If you use TFTP to upgrade or restore the router’s file system, be sure to
specify the software image file (an.exe for the AN/ANH or arn.exe for the
ARN).
Bay Networks supports BootP service on UNIX workstations, but not PCs. If
you want to netboot and you are using a PC as your Site Manager
workstation, transfer the files you want to netboot from the PC to a UNIX
workstation and configure the workstation as a BootP server.
On a BayStack router, you cannot use EZ-Install or Netboot directly from a
FDDI interface. On an AN/ANH, you cannot use EZ-Install or Netboot
directly from a token ring interface.
You need BayRS Version 8.10 or later to use Directed Netboot.
If you have a LAN protocol analyzer available, you may want to use it to
troubleshoot BootP server communication errors. (See “Guidelines for Using
Packet Capture” and “Guidelines for Using a LAN Protocol Analyzer” on
pa
ge B-9 for information about using the Packet Capture utility or an analyzer
to isolate these errors.)
BayRS Versions earlier than 7.80 do not include the Packet Capture utility.
The 12-port ANH polls the internal repeater module for operational status; it
does not poll individual Ethernet repeater ports for connection (link) status.
Therefore, the 12-port ANH is aware of the connection between the baseboard
and repeater module, but is not aware of any connection between the repeater
module and the Ethernet network. If the repeater module interface state
reports an operational status, the 12-port ANH may continue to transmit
information through the repeater module even though a physical Ethernet
connection does not exist.
At the AN Monitor prompt, you cannot view the contents of the local file
system on the flash memory card. Be sure to remember the name of the
configuration file when performing a Directed Netboot from the AN Monitor
prompt.
You can issue a
boot command from the AN Monitor prompt. Specify a local
boot by entering
1: for the volume name.
Przeglądanie stron 143
1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 167 168

Komentarze do niniejszej Instrukcji

Brak uwag