Avaya Troubleshooting Routers Instrukcja Naprawy Strona 122

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 121
Troubleshooting Routers
6-14 117379-A Rev. A
Endstation Can Ping Local and Remote Interfaces on the Router, but
Cannot Ping a Remote Station
If the endstation can ping the local and remote router interfaces but cannot ping a
remote station, do the following:
1. Ping the device on each link in the path between the source and
destination to determine the location of the problem.
2. Make sure that the next hop for each network points to the correct
interface.
3. Ping from the remote station to the local station.
This verifies that each router in the path not only has a route to the remote
segment but also has a path back to the originator of the ping request.
Troubleshooting RIP
If the router cannot reach a network or host, determine whether there is an entry
for the network or host in the routing table. If the entry is in the routing table,
determine whether the next hop and metric are correct.
If the entry is not in the routing table, do the following:
1. Determine whether the router enabled RIP.
2. Set RIP Listen on the RIP interface.
3. Determine whether a RIP station on an attached network is sending RIP
packets.
4. Use Packet Capture or a network analyzer to capture the RIP packets
and verify the accuracy of the advertisements from other RIP stations.
Note: Use the Site Manager or Technician Interface path option when pinging
the remote station. This option provides the same functionality as the UNIX
traceroute command.
Przeglądanie stron 121
1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 265 266

Komentarze do niniejszej Instrukcji

Brak uwag