Avaya Configuring WAN Line Services Instrukcja Użytkownika Pobierz pdf (Strona 168)

Configuring WAN Line Services

8-8

117345-B Rev. 00

The carrier determines signal levels on a long-haul (0 to 6000 ft. of cable) T1

network interface. If 0.0 dB is not sufficient for long-haul, the carrier determines

values of -15 and -7.5 dB.

Signal power for DSX-1 short-haul (0 to 655 ft.) is based on cable length.

For DSX-1, decibel levels correspond to cable length, as follows:

• 0.0 dB -- 0 to 133 ft.

• 0.5 dB -- 133 to 255 ft.

• 0.8 dB -- 255 to 399 ft.

• 1.1 dB -- 399 to 533 ft.

• 1.5 dB -- 533 to 655 ft.

By default, the signal level is 0.0 dB. Set the long-haul or short-haul signal level

for this FT1 interface according to the length of the cable or as the carrier

specifies.

See the Signal Level (dB) parameter on page A-45

for information.

Setting the Alarm Threshold Time

By default, the FT1 interface waits 2 seconds before logging a performance defect

or anomaly as an event message. Change the alarm threshold time to any value

from 2 to 10 seconds.

See the Setup Alarm Threshold (seconds) parameter on page A-46

for

information.

Setting the Alarm Threshold Clear Time

By default, the clear time for performance-failure conditions is 2 seconds. If the

defect or anomaly clears in this time interval, FT1 records a performance-cleared

condition and logs an event message. You can change the alarm threshold clear

time to any value from 2 to 10 seconds.

Set the alarm threshold clear time for this FT1 interface.

See the Clear Alarm Threshold (seconds) parameter on page A-46

for

information.

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 293 294

Brak uwag

Avaya Configuring WAN Line Services Instrukcja Użytkownika Strona 168