Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Instrukcja Użytkownika Strona 72

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 233
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 71
70 Chapter 2 General CLI commands
212160-B
default ip address unit command
The default ip address unit command sets the IP address for the specified
unit in a stack to all zeros (0). The syntax for the
default ip address unit
command is:
default ip address unit <1-8>
The default ip address unit command is in the config command mode.
Table 19 describes the parameters and variables for the
default ip address
unit
command.
Note: When you change the IP address or subnet mask, you may lose
connection to Telnet and the Web.You also disable any new Telnet
connection, and you must connect to the serial console port to configure
a new IP address.
Table 19 default ip address unit command parameters and variables
Parameters and
variables
Description
unit <1-8> Zeroes out the IP address for the specified unit.
Note: When you change the IP gateway, you may lose connection to
Telnet and the Web.
Przeglądanie stron 71
1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 232 233

Komentarze do niniejszej Instrukcji

Brak uwag