
Configuring Enterprise Edge Services 167
P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide
• Nine Hundred
This service is commonly referred to as fixed charge dialing.
•Private
Privateincoming and outgoingcalls connect Enterprise Edge toa virtual private
network. Dialed digits may conform to the standard North American dialing
plan (E.164 standard) or the dialed digits may use a private dialing plan.
Programming Call by Call on PRI requires you to program various areas of the
Enterprise Edge system such as:
• Under Line Access, assign the line pool.
• Under Services, in routing servicessection, assign which pool to use for routing
and which service type, and service id if required.
• Under General settings, specify the minimum and maximum values for the
pools.
Enterprise Edge
Service types1
NI-26 DMS-100
(custom)
DMS-250
(MCI, Sprint,
Generic)
AT&T 4ESS
FX FX FX
2
Tie
3
Tie Tie Tie SDN
(software defined
network)
INWATS INWATS INWATS Eight Hundred Toll Free
MEGACOM
International
INWATS
Same as
INWATS
Same as
INWATS
Same as
INWATS
International
Toll Free
Service
OUTWATS IntraLATA
OUTWATS
OUTWATS with
bands
InterLATA
OUTWATS
OUTWATS PRISM MEGACOM
Private
DMS Private
5
VNET
(virtual network)
Switched Digital ACCUNET
4
Nine Hundred Nine Hundred MultiQuest
Public Public Public Public
1. A shaded box indicates that the protocol does not support the service.
2. DMS-250 Sprint and UCS support incoming FX only (i.e. Network-to-Enterprise
Edge). DMS-250 MCI does not support FX.
3. NI-2 allows two Tie operating modes: senderized and cut-through. Enterprise Edge
will only support senderized mode.
4. Rates greater than 64 kbps will not be supported.
5. Bell Canada VNET.
6. Not all service types may be supported by a switch type. For information,
contact your service provider.
Komentarze do niniejszej Instrukcji