Avaya Integrated Management Release 3.1 Standard Management Instrukcja Użytkownika Pobierz pdf (Strona 36)

VoIP Monitoring Manager Installation

36 Avaya Integrated Management Standard Management Installation and Upgrade

Configuring the IP Network Region Form

Figure 1 shows an IP Network Region form. To configure this form, follow these steps:

1. Set the RTCP Reporting Enabled? field to y (yes).

2. Set the Use Default Server Parameters? field to y (yes). This indicates that this

network region uses the default values specified on the System Parameters IP-Options

form.

Figure 1: IP Network Region Form

In some cases, you may not want to set the Default Parameters to yes. Set the field to n (no)

and specify the IP address of the Windows PC running the server for that network region.

An example of when you might not want to set the Default Parameters to yes is if you have

multiple servers installed on a large system in order to reduce the network traffic between a set

of endpoints and the RTCP Monitor (for example, low bandwidth link between endpoints in one

network region and a remote RTCP Monitor). The network traffic resulting from RTCP reports

being sent from the endpoints to the RTCP Monitor is usually low, less than 40 bytes per

second per currently active VoIP call (RTP session). Therefore, it is usually unnecessary to

have multiple RTCP Monitors.

If multiple Servers are installed on the system, the endpoints in each network region can be

configured to send their RTCP reports to different RTCP Monitors.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42

Brak uwag

Avaya Integrated Management Release 3.1 Standard Management Instrukcja Użytkownika Strona 36