Avaya R2MFC Przewodnik Konfiguracji Pobierz pdf (Strona 31)

R2MFC Media Bay Module Installation and Configuration Guide

Chapter 3

Installing the R2MFC MBM

This chapters describes how to install and remove an R2MFC MBM in a host BCM system.

This chapter provides the following installation and removal procedures:

• “Shutting down the system”

• “Installing an R2MFC MBM” on page 32

• “Removing an R2MFC MBM” on page 35

• “Wiring an R2MFC MBM” on page 37

Figure 7 provides an overview of the steps for installing the R2MFC MBM.

Figure 7 Overview of the R2MFC MBM installation

Shutting down the system

Before you shut down the system or perform any maintenance procedures, read the following

warnings to ensure you and your system are properly protected.

Warning: If you are installing a new BCM or an expansion unit, refer to the

Installation and Maintenance guide for the host system for instructions about installing

a new system before you connect the system to the AC power outlet.

Set module DIP

switches

Disconnect power from

both units

Disconnect cables from

the front of the server and

expansion unit

Remove front bezel from

the expansion unit to

eject blank filler on MBM

Install new module

Replace bezel

Restore power to BCM

and expansion unit

Reconnect all cables

Monitor LEDs for power

and status

Is this

installation part

of a new system

installation?

Continue with

system initialization

Use the Unified Manager

to identify the module to

the system

NO YES

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 105 106

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya R2MFC Przewodnik Konfiguracji Strona 31

Komentarze do niniejszej Instrukcji