Avaya Configuring Data Compression Services Instrukcja Użytkownika Strona 32

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 103
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 31
Configuring Data Compression Services
2-2
117352-D Rev. 00
Bay Networks Compression Services
Bay Networks compression services include:
Software-based compression for PPP, frame relay, and X.25 networks for all
router platforms and all serial interfaces.
PPP compression works on multiline, multilink, on the ISDN BRI and PRI
modules, and on lines that use Raise DTR or V.25bis modem interfaces with
dial services. Frame relay compression works on multiline and dial backup
lines.
Hardware-based compression for PPP and frame relay networks for BN
routers using one of the following modules:
-- Octal synchronous link module using FRE-2 processors
-- FRE-2-060E processor module with the advanced compression
coprocessor daughterboard to which you can connect a broad range of
Bay Networks link modules (see “Hardware-Based Data Compression for
the BN Platform” on page 1-3 for the list of supported link modules).
Hardware compression on the BN supports all PPP and frame relay services
that WCP software compression supports.
Hardware-based compression for PPP and frame relay networks for the ASN
router.
A compression net module compresses data transmitted over a WAN network
by dual and quad synchronous, MCE1/ISDN PRI, MCT1/ISDN, dual
synchronous with ISDN BRI, and Quad BRI net modules. Hardware
compression on the ASN supports all PPP services that WCP software
compression supports.
Bay Networks WCP software- and hardware-based compression interoperate fully
because they use the same algorithm.
Hi/fn LZS hardware compression is supported by the FRE-2-060E processor with
the advanced compression coprocessor daughterboard for the BN when
connecting to a router from another vendor that is also running the Hi/fn LZS
algorithm.
To use software data compression effectively, you must decide how to allocate
memory for this task. The goal is to compress data as much as possible and to
transmit the data as quickly as possible without taxing the resources of the router.
Przeglądanie stron 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 102 103

Komentarze do niniejszej Instrukcji

Brak uwag