Avaya Configuring Data Compression Services Instrukcja Użytkownika Pobierz pdf (Strona 23)

Starting Compression

117352-B Rev. 00

1-5

Configuring Software Compression

Software compression works on all router platforms and all serial interfaces. After

you open a configuration file, go to the one of the following sections to enable

compression.

•“Enabling Compression for PPP and Frame Relay

”

•“Enabling Compression for X.25

,” on page 1-6

Enabling Compression for PPP and Frame Relay

To configure software compression for PPP and frame relay, begin at the

Configuration Manager window and complete the tasks in the following table:

Site Manager Procedure

You do this System responds

1. Click on the link or net module connector

for which you are enabling data

compression.

The Add circuit window opens.

2. Accept the default circuit name or rename

the circuit then click on

The WAN Protocols window opens.

3. Choose one of these WAN protocols:

• PPP

• Frame Relay

Site Manager enables the protocol.

4. Click on

. The Select Protocols window opens.

5. Enable data compression according to the

appropriate procedure.

•For

PPP

, scroll through the Select

Protocols window and choose

either

WCP

Stac LZS.

•For

Frame Relay

, scroll down the

Select Protocols window and choose

WCP

* WCP and Stac LZS cannot operate on the same line. Do not configure them together on a line.

Site Manager enables compression on

this interface.

6. Click on

. You return to the Configuration Manager

window.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 71 72

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya Configuring Data Compression Services Instrukcja Użytkownika Strona 23

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Avaya Configuring Data Compression Services