Avaya Configuring Data Compression Services Instrukcja Użytkownika Pobierz pdf (Strona 23)

114061 Rev. A

1-1

Chapter 1

Starting Compression

The quickest way to begin using data compression on your network is to enable it

with the default values that Bay Networks software supplies. The procedures in

this chapter describe how.

Preparing a Conﬁguration File

Before you can start data compression, you must:

Create and save a conﬁguration ﬁle that has at least one WAN interface.

Retrieve the conﬁguration ﬁle in local, remote, or dynamic mode.

Specify router hardware if this is a local mode conﬁguration ﬁle.

Conﬁguring Software Compression

Software compression works on all router platforms and all serial interfaces. You

can use software compression with Frame Relay, PPP, or X.25.

To conﬁgure software compression:

Select the link or net module connector on which you are enabling data

compression.

Specify Frame Relay, PPP, or X.25 as the WAN protocol.

For further information about these steps, refer to

Conﬁguring Routers

Site Manager Path:

From the Protocols window that appears after you

select the link or net module, select PPP, Frame Relay, or X.25. Click on

OK. The Select Protocols window appears.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 53 54

Brak uwag

Avaya Configuring Data Compression Services Instrukcja Użytkownika Strona 23