Avaya Connecting ASN Routers to a Network Instrukcja Użytkownika Pobierz pdf (Strona 34)

Connecting ASN Routers to a Network

1-16

308652-14.00 Rev 00

Completing a Network Boot Option

This section lists the steps required for

• EZ-Install

• Netboot

• Directed Netboot

To proceed with the Local Boot option, go directly to the manual Quick-Starting

Routers.

EZ-Install

The EZ-Install option requires the following steps:

You use the Configuration Manager in local mode to create a complete

configuration file for the router.

(See Chapter 3 and the manual Configuring and Managing Routers with Site

Manager.)

You set up the network to support BOOTP.

(See Chapter 2.)

You create a BOOTP relay interface table on the upstream router to

support automated addressing, and configure all routers between the

BOOTP server and the booting router as BOOTP relay agents.

(See Chapter 2.)

Note:

To boot an ASN over the network, the ASN must be running Router

Software Version 8.10 or later (or BayStream Software Version 5.00 or later),

and all routers in the path between the ASN and the BOOTP server must be

running Version 7.60 (BayStream 5.00) or later.

Note:

To use EZ-Install over a Frame Relay circuit, make sure the upstream

router is running BayRS Version 7.80 or later (or BayStream Software Version

5.00 or later).

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 107 108

Brak uwag

Avaya Connecting ASN Routers to a Network Instrukcja Użytkownika Strona 34