Avaya CallPilot Message Networking Instrukcja Użytkownika Pobierz pdf (Strona 44)

Chapter 4 Setting up AMIS

P0919429 06

Sending a test network message

To test network message capability you must send a message from your site to the Loopback

mailbox at a site on the AMIS network. When the Loopback mailbox at the destination site

receives the message, it automatically returns the message to the mailbox used at the originating

site. If you use the System Administrator's Mailbox, the test message you record is left as a

message in your System Administrator Mailbox. If you receive the message, it indicates Network

Messaging is operating properly. If you do not receive the message or if a protocol error occurs,

refer to “Troubleshooting Non Delivery Notification messages” on page 57.

Use the procedure that corresponds to your mailbox interface. For information on determining

which mailbox interface you use, see the CallPilot Reference Guide.

To send a test network message using the AMIS Loopback mailbox -

Norstar Voice Mail

1 Press

Follow the voice prompts or the display button options to open

your mailbox.

2 Press

REC

or .

After the tone, record a message.

3 Press

or to end the recording.

4 Press

or to accept the recording.

5 Press

6 Press

AMIS

7 Enter the system phone number of the destination site

and press

or .

8 Press

or .

9 Enter the Loopback mailbox number and press

or .

10 Press

OTHR

or .

11 Press

SEND

12 Press

to end the programming session.

0 new 0 saved

PLAY REC ADMIN

Record message:

RETRY PAUSE OK

Accept rec?

RETRY PLAY OK

Mbox:

DIR QUIT

Address Type?

NETW AMIS

Dest Ph:

RETRY OK

ADD OK

Dest mb:

RETRY OK

AMIS msg:

OPTS CC OTHR

Network msg:

VIEW SEND

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 73 74

Komentarze do niniejszej Instrukcji

Brak uwag

Avaya CallPilot Message Networking Instrukcja Użytkownika Strona 44

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Avaya CallPilot Message Networking