4
Q00228099:
PP5430 ATM T1
Bouncing an PP5430 ATM T1 interface under load may result in a fault on the router.
Q00245641-01: TI
The TI_INIT process does not release memory on FRE4 and ARE modules when the Serial Port
ModemEnable attribute is enabled. If many login requests are made, this could eventually cause
an out of memory fault on the router.
Q00156420-01: Radius Accounting
Different session IDs are used for the Radius accounting stop and start messages for LNS
sessions making it difficult to correlate the start/stop pairs for each session.
Q00217703-01: TI
The atmarp command may hang when a large number of PVCs are configured.
Q00248132-01: SNMP
The router will fault when an SNMP request packet is received that contains a variable length field
value that is greater than the actual size of the data.
Q00233303: BCC_Circuitless IP
A circuitless IP 32 bit mask interface cannot be added after deleting it using BCC.
Q00250617: ATM
ATM service record remains in IDLE state if the service record is bounced while under heavy load.
Q00229640-01: ATM_PQ
ATM PVCs configured with priority queuing fail to recover after a remote side disconnect.
Q00246791: PP2430
Using the prom –v or prom –w command on the pp2430boot.ppc file on the PP2430 router will
cause the router to fault. The boot prom is not supported on the PP2430 router.
Q00254601-01:
IP_Multicast
The router may send multicast packets out of sequence when unicast traffic is received
simultaneously.
Q00206828-01:
Ping MIB
The Ping MIB wfPingTypeOfService attribute was changed to obsolete in BayRS 15.1.0.0 causing
third party applications that set this MIB to fail. The MIB is now read-write again, but the only valid
value is 1.
Q00251246:
PPP
The IPCP type 1 address negotiation fails subsequent to a type 3 address negotiation failure.
Q00253951-01: IP
IP doesn't send an ICMP redirect packet when it is on the same interface that the original packet
came in on.
Komentarze do niniejszej Instrukcji