Avaya COMPANION Przewodnik Konfiguracji Pobierz pdf (Strona 18)

18 Chapter 1 Installing the Companion system

P0605793 02

3 Hang the RPI on the two screws and tighten the screws.

4 Install the remaining two screws.

5 Feed the power cord through the bottom of the RPI.

6 Route it through the clip and around the strain relief support. The following figure shows how

to route the power cord.

Figure 5 RPI components

7 Route the power cord to the input power socket just to the left of PSU 1, on the left.

8 Connect the plug to the socket.

9 Follow the appropriate wiring instructions in the wiring charts in the next section, “Wiring the

base station and connecting the RPI”.

10 After the cable is wired correctly, connect the RPI power cord to the ac outlet.

11 Label each RPI.

Caution: Do not apply power to the RPI until its installation and wiring are complete.

PSU 1 PSU 2

(if equipped)

Up to 16 outputs

(TCM + power)

Up to

inputs

(TCM)

Connection board

Jumper lead to PSU 2

Power cord

Grounding strap

Power supply cabling

Strain relief support

Clip

Grounding plates

Ferrite rings

The RPI-8 has grounding straps and

plates fitted to allow an upgrade to

an RPI-16.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Brak uwag

Avaya COMPANION Przewodnik Konfiguracji Strona 18