Avaya R5.0: Przewodnik Konfiguracji Pobierz pdf (Strona 5)

BCM Rls 5.0 Configuration Guide For: MTS/Allstream SIP Trunking

2009-00002508 Page 5 of 20

2.0 System Software

This section provides what system software versions were tested on the Nortel BCM50 Release 5.0 and

MTS/Allstream’s SIP Trunk Service.

Note

: Nortel recommends installing the latest Smart Update (SU) Patch, which will contain previous patches and

new fixes. The patches can be downloaded on the Nortel Technical Software Downloads Support site:

http://support.nortel.com/go/main.jsp

The BCM50 R5.0 was tested with BCM50 R5.0 SU Patch (BCM050 [1].R500.SU.System-001.200911-1) while

connected to the MTS/Allstream SIP Trunk service.

To achieve successful interoperability between the BCM and MTS/Allstream SIP Trunk service, the various

network elements must be running the version of software as shown below in Table 1:

System Software/Loadware Version

Nortel BCM50

• BCM R5.0 Base S/W: 9.0.1.00

• Patch: BCM050.R500.SU.System-

001.200911 or higher

CS2000

• CS2K SN09U

Nextone SBC

• Rel v4.3m3

Table 1 Validated Equipment and Software

The Nortel Networks BCM must be running at least software version 9.0.1.22.XXX

. You can check the version of

BCM by viewing the following screen under Configuration

System

Identification.

The following specifications have been considered

SIP RFC3261

IP Codec: G711U and G729; Packet (frame) size: 20ms

DTMF: in band, RFC2833

Caller ID: P-Asserted-ID as per RFC3325 (Remote-Party-ID header supported but not recommended -

deprecated-)

Caller ID blocking as per RFC3325 (Privacy id header)

Re-Invite to 0.0.0.0 or a=sendonly are supported for on-hold

G711 pass-through used for fax transmissions

Early-Media is supported

G729 is the preferred codec on Allstream side

1 2 3 4 5 6 7 8 9 10 ... 19 20

Brak uwag

Avaya R5.0: Przewodnik Konfiguracji Strona 5