Avaya Ethernet Link Modules in BN Platforms Instrukcja Użytkownika Pobierz pdf (Strona 29)

114946-A Rev. A 3-1

Chapter 3

Checking Status Indicators

This chapter describes the status indicator lights (LEDs) on the Ethernet link

modules. Use the LEDs to verify that the link module is operating after

installation.

Ethernet LEDs

The LEDs on the Ethernet connector panels vary depending on which module you

have. Figure

3-1 shows the LEDs on the Dual Ethernet, Quad Ethernet, and Dual

Ethernet High-Speed Filters link modules. T

able 3-1 describes those LED

functions. For information on the Dual 100Base-T Ethernet link module LEDs,

see the next section.

Note: We recommend that you issue the diags command to the associated

slot, using the Bay Networks Technician Interface, immediately after you

insert a link module. (Refer to Using Technician Interface Software if you use

router software or Troubleshooting and Testing if you use BayStream

software.) Otherwise, the link module FAIL LED will remain lit, indicating

that diagnostics have not run on the Intelligent Link Interface (ILI). However,

even if you do not issue the

diags command, the link module initializes and

becomes operational as long as the board functions properly and contains the

correct interface conﬁgurations.

1 2 ... 24 25 26 27 28 29 30 31 32

Brak uwag

Avaya Ethernet Link Modules in BN Platforms Instrukcja Użytkownika Strona 29