Avaya Quick-Starting Routers and BNX Platforms Instrukcja Użytkownika Pobierz pdf (Strona 114)

Quick-Starting Routers and BNX Platforms

B-2

• Editing the autoexec.bat and conﬁg.sys ﬁles to delete references to the old

version of Distinct and the other networking software.

3. Roboot the PC.

4. Enter win to start Windows.

5. Insert the Distinct installation disk in the disk drive.

6. Select File➔Run.

7. Enter A:\setup and run Distinct.

8. Accept the default to “Add Library to Path.”

9. Accept defaults for the destinations for the program and driver.

10. Accept defaults to create the directories for the program and drivers.

The program then copied ﬁles from the disk to the created directories.

11. Enter the Distinct serial number and key code from Table 7-1 in

Chapter 7

12. Accept the prompt to select and set up a network interface card.

Skip this step if you already have a NIC installed or if you are using SLIP or

PPP over a modem.

13. From the Choose Adapter menu, choose the EtherLink III (3C509B) card

that was installed in the PC.

14. Select the NDIS driver type as opposed to Packet or ODI type.

15. Copy the driver from the disk when prompted to supply a location for the

card driver.

16. Click on OK on the request to update the autoexec.bat. conﬁg.sys, and

protocol.ini ﬁles.

17. Choose to deﬁne a host instead of dynamically deﬁning it using the

BOOTP or RARP protocols.

18. Deﬁne our host’s Name and Internet Address (192.---.---.---).

19. Choose not to enter a Domain Server Name.

20. Choose to enter a Default Server Gateway.

Note: You can only run one TCP/IP stack at a time.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 120

Brak uwag

Avaya Quick-Starting Routers and BNX Platforms Instrukcja Użytkownika Strona 114